Is due to the low or low melt temperature, mold temperature, shoot rubber pressure is insufficient, caused by the combin...

Inlet temperature is too high or too low, will cause the machine back to the material is not stable, so that the amount ...

Transparent products are white spots are because of cold glue into the product or material has caused by dust. Increase...

njection molding machine hydraulic oil requirements: (1) the proper viscosity and good viscosity temperature properties...

When system working environment of high temperature, the higher viscosity of the oil, on the contrary, the low viscosity...

Raw material dry enough; product glue phenomenon of uneven thickness, mold exhaust bad, raw material is easy to decompos...